Can this work at all? 3D print weight test

For hand launch, my personal insurance and the plane’s general ability to fly sensibly, the mass of the airframe, as constructed must be minimized. With this test wing, according to Cura, the mass of this 180 mm by 180 mm wing segment is around 45 g, bringing the whole wing weight to ca. 150 g - works for me.

Cura Settings:

• Material Density 1.2 g/cm³
• 1 perimeter
• 0 % Infill
• 3 Bottom Layers
• 0.45 mm Line Width

Wing Segment

So this project might be possible :) _{Also I wanted to test/show off my 3D part visualization}